Note
• F4 is displayed only when " totl" is selected in F2 (input selection).
• Alarm ( indicator) will be displayed when either total time (F3) or total
count (F4) reaches the set alarm value.
•
If an alarm value for the total count is set to 0, the alarm indicator does not appear.
• To leave initial setting mode, press for 3 s or more.
• If is pressed again before confirming the setting, the setting is
cancelled.
- 51 -
Weekly
2 chnls
Yearly
2 chnls
Yearly
4 chnls
The alarm value can be set for the total count.
( 6-1)
Setting
The setting is made in F4 (total count alarm) of initial setting mode.
Press for 3 s or more in program
setting mode to enter initial setting mode.
Give short presses on and
move to the F4 display.
Press to confirm the setting.
(After a one second pause, the screen returns to the initial display of F4.)
WRITE
6-6-4. F4: Total Count Alarm
Setting range
0 to 999900 (6 digits)
Count is set in the hundreds.
The default is 0 (The alarm indicator output is off).
The color indicates flashing.
TIME ADJ
TIME ADJ
TIME ADJ
TIME ADJ
Set the Mode Switch to RUN.
Alarm value setting display appears
automatically in 2 s after entering F4.
Press or to set an alarm value.
decrements the value of the Key that was last pressed.)
: increments in 1,000 hour unit.
: increments in 10 hour unit.
m
h
h
m
(Pressing HOLIDAY/
SELECT PRGM/or
To Next Page
Loading...
