Omron H5S - Manual Operation on Recovery from Power Failure; Time Adjustment Input Function

- 44 -
Weekly
2 chnls
Yearly
2 chnls
Yearly
4 chnls
Time can be set to 00 min 00 s at the same time as external
input is applied. When group-mounting two or more Time
Switches, their times can be synchronized.
Note
• Before using this function, input
assignment is required.
( Section 6-6-2)
• This function cannot be used
when power is OFF.
• Refer to "Section 3. Wiring" in
the Installation for wiring.
6-3. Manual Operation on Recovery from Power Failure
Weekly
2 chnls
Yearly
2 chnls
Yearly
4 chnls
After power is restored to the H5S, it is possible to set the Time
Switch to stop turning ON output until external input is applied.
Note
• This function is useful to
prevent output from
automatically turning ON after
recovery from power failure.
• Before using this function, input
assignment is required.
( Section 6-6-2)
• Refer to "Section 3. Wiring" in
the Installation for wiring.
Power
supply
ON OFF Flashing ON
6-2. Time Adjustment Input Function
(In the upper left corner of the screen)
Times of two or more H5S Time Switches can be synchronized.
Time synchronization possible!
Master Slave Slave
<Configuration example>
Input Input
Output
The master unit is set to
turn ON pulse-output on
the hour (e.g. at noon)
using output that is not
used.
indicator
External
input
Output