39
2. Repeatedly press the Mode Key until the len word length setting is dis-
played.
Set Value LED Display Model Basic Model
3. Press the Shift Key to display the prior set value 7 for changing. The PROG
indicator will flash.
Set Value LED Display Model Basic Model
4. Press the Up Key to set the value to 8. The input value will be validated auto-
matically if no change is made for five seconds. The len word length setting
will be displayed again.
Note Press the Mode Key to enter the set value immediately. The next pa-
rameter will be displayed for setting.
Set Value LED Display Model Basic Model
5. Press the Mode Key to display the sbit stop bit setting.
Set Value LED Display Model Basic Model
6. Press the Shift Key to display the set value 2 for changing.
Set Value LED Display Model Basic Model
7. Press the Up Key to set the value to 1. The input will be validated automati-
cally if no change is made for five seconds. The sbit stop bit setting will be
displayed again.
Note Press the Mode Key to enter the set value immediately. The next pa-
rameter will be displayed for setting.
Set Value LED Display Model Basic Model
8. Press the Mode Key to display the prty parity bit setting.
Set Value LED Display Model Basic Model
Setting Mode
Section 3-2
AUDIN - 7 bis rue de Tinqueux - 51100 Reims - France - Tel : 03.26.04.20.21 - Fax : 03.26.04.28.20 - Web : http: www.audin.fr - Email : info@audin.fr
To Next Page
Loading...
