Before you Begin
41
User can set PLC communication parameters like Baud Rate, Parity, Data Bits and Stop Bits.
Click ‘Ok’ to set parameters.
Model - User can select desired PLC model from the list available. In the example shown
above, user has selected ‘CJ1’ model.
Address - Unique PLC node address ( 0 to 32 ).
Name - User can specify node name, which can be maximum up to 15 characters.
Add a Node - User can add a node in the network.
Change a Node -
User can change PLC or PLC related information. First of all user has to select the
node. Then change the information and finally click the button ‘Change a Node’.
PLC specific data -
If additional information is required for PLC, user can select the node. Then this button
is activated. Now by clicking on this button user can provide the desired information.
Delete node - To delete a node, first of all user has to delete all the tags defined for the node. Then
user has to select the node and click the Delete button.
Omron Frame delay can be set using the screen shown below:
Port Settings -
To Next Page
Loading...
