Omron OMNUC R88D-WT15HF User Manual

6-27
Parame-
ter No.
Restart
power?
Setting
range
UnitDefault
setting
Explanation (See note 1.)Parameter
name
Parame-
ter No.
Restart
power?
Setting
range
UnitDefault
setting
Explanation (See note 2.)Set-
ting
Name
Digit
No.
Parameter
name
Pn51C
**
Not used. (Do not change setting.) 450 --- --- ---
Pn51E
**
Deviation
counter
overflow
warning
level
Sets the detection level for the deviation counter overflow
warning. (Set as a percentage of the deviation counter
overflow level (Pn505).)
0 % 0 to 100 ---
Note 1. Explanation for parameters set using 5 digits.
Note 2. Explanation for parameters requiring each digit No. to be set separately.
H Other Parameters (From Pn600)
Parameter
No.
Parameter
name
Explanation Default
setting
Unit Setting
range
Restart
power?
Pn600 Regeneration
resistor ca-
pacity
Setting for regeneration resistor load ratio
monitoring calculations
Note The normal setting is 0. If an external
regeneration resistor is used, refer to
3–3–3 Regenerative Energy Absorp-
tion by External Regeneration Resist-
ance for the recommended setting.
0 x 10 W From 0
(varies by
Unit.)
---
Pn601 Not used. (Do not change setting.) 0 --- --- ---
Appendix Chapter 6

Omron OMNUC R88D-WT15HF Specifications

General

Brand	Omron
Model	OMNUC R88D-WT15HF
Category	Servo Drives
Language	English