Omron R88D-1SN ECT Series Startup Guide

7
Related Manuals
The following manuals are related. Use these manuals for reference.
Manual name Cat. No. Model Application Description
Sysmac Studio Version 1
Operation Manual
W504 SYSMAC-SE2□□□ Learning about the operating
procedures and functions of
the Sysmac Studio.
Describes the operating procedures of
the Sysmac Studio.
Sysmac Studio Drive
Functions Operation
Manual
I589-E1 SYSMAC-SE2□□□ Learning about the operating
procedures and functions of
the Sysmac Studio for Drives
Describes the operating procedures of
the Sysmac Studio to setup Drives
NJ-series CPU Unit
Hardware User´s Manual
W500 NJ501-□□□□
NJ301-□□□□
Learning the basic
specifications of the
NJ-series CPU Units,
including introductory
information, designing,
installation, and
maintenance.
Mainly hardware information
is provided.
Provides an introduction to the entire
NJ-series system along with the
following information on the CPU Unit.
• Features and system configuration
• Overview
• Part names and functions
• General specifications
• Installation and wiring
• Maintenance and inspection
Use this manual together with the
NJ/NX-series CPU Unit Software
User's Manual (Cat. No. W501).
NJ/NX-series CPU Unit
Software User’s Manual
W501 NJ501-□□□□
NJ301-□□□□
Learning how to program and
set up an NJ/NX-series CPU
Unit.
Mainly software information is
provided.
Provides the following information on a
Controller built with an NJ/NX-series
CPU Unit.
• CPU Unit operation
• CPU Unit features
• Initial settings
• Language specifications and
programming based on IEC 61131-3
Use this manual together with the
NJ-series CPU Unit Hardware User's
Manual (Cat. No. W500).
NJ/NX-series CPU Unit
Motion Control User's
Manual
W507 NJ501-□□□□
NJ301-□□□□
NJ101-□□□□
Learning about motion
control settings and
programming concepts.
Describes the settings and operation of
the CPU Unit and programming
concepts for motion control.
When programming, use this manual
together with the NJ-series CPU Unit
Hardware User's Manual (Cat. No.
W500) and NJ/NX-series CPU Unit
Software User's Manual (Cat. No.
W501).
NJ/NX-series Instructions
Reference Manual
W502 NJ501-□□□□
NJ301-□□□□
Learning detailed
specifications on the basic
instructions of an
NJ/NX-series CPU Unit.
Describes the instructions in the
instruction set (IEC 61131-3
specifications).
When programming, use this manual
together with the NJ-series CPU Unit
Hardware User's Manual (Cat. No.
W500) and NJ/NX-series CPU Unit
Software User's Manual (Cat. No.
W501).

Omron R88D-1SN ECT Series Specifications

General

Brand	Omron
Model	R88D-1SN ECT Series
Category	Controller
Language	English