98
Other Settings Section 6-5
Initializing the
Support Tool's
Parameters
When you want to initialize the parameters in the Support Tool, select Edit -
Initialize.
Note This operation does not directly initialize the S8M's parameters; it just initial-
izes the parameters in the display windows.
Initializing the S8M's
Parameters
1. When you want to initialize the parameters in the S8M, select Communi-
cations - Initialize Parameters.
2. This operation writes the default values to the S8M's parameters. If the
S8M's parameters were initialized properly, the following message will be
displayed.
3. The following operations are performed when the S8M's parameters are
initialized.
• The operating mode is changed to Setting Mode.
• Each parameter is changed to its default value.
• Each branch output is disconnected.
• The protection level is changed to level 1.
Reading the Version 1. The S8M Support Tool's version number can be read.
Select Help - Version.
2. The Support Tool's version number will be displayed.
▲
Version number
To Next Page
Loading...