Omron S8M - 4-5 Switching to Setting Mode

55
Switching to Setting Mode Section 4-5
4-5 Switching to Setting Mode
A newly purchased S8M will start in Setting Mode when it is turned ON for the
first time. In this case, the seven-segment display will show the current trip-
ping value for branch output 1 (C-V). (For details, see page
56.)
If the S8M was previously turned ON and turned OFF in any mode other than
Test Mode, it will start in Run Mode the next time that the power is turned ON.
If the S8M was turned OFF in Test Mode, it will start in Test Mode the next
time that the power is turned ON.
To switch to Setting Mode from Run Mode or Test Mode, select Setting Mode
from the Mode Selection Menu, as shown below. The Mode Selection Menu
can be displayed by pressing both the Up Key ( ) and Down Key ( ) simul-
taneously for 3 seconds.
Selecting the Operating Mode from the Mode Selection Menu
r u n
s e t
c - V
The "A" unit indicator will
be lit when a current is
displayed.
Branch output number 1 is lit.
23
4
°C
kh
V
A
s
1
23
4
°C
kh
V
A
s
1
23
4
°C
kh
V
A
s
1
If the S8M is switched to the Mode Selection
Menu from Run Mode, RUN (select Run Mode)
will be displayed.
Press the Down Key ( ).
When the Down Key ( ) is pressed, SET
(select Setting Mode) will be displayed.
If the Mode Key ( ) is pressed, the S8M will
switch to Setting Mode.
The initial display for Setting Mode will be dis-
played.
The initial Setting Mode display is the current tripping value for branch output 1 (C-V). Once the S8M
is switched to Setting Mode, it will not return to Run Mode automatically.
(To return to Run Mode, press the and Keys simultaneously for 3 seconds again.)
For details on setting parameters in Setting Mode, refer to 4-6 Individual Branch Output Settings.