Omron S8M - 5-4 Run Mode

78
Run Mode Section 5-4
5-4 Run Mode
Switch to Run Mode after making connection settings and testing operation in
Test Mode. When Run Mode is entered from Test Mode, the initial status of
the branch outputs will be set. In Run Mode, the present current and peak out-
put current can be read out for branch outputs 1 to 4, along with the total cur-
rent, run time, and internal temperature. The peak output currents can also be
cleared.
Moving from Test
Mode to Run Mode
+
t s t
s e t
r u n
2 $ 0
23
4
°C
kh
V
A
s
1
23
4
°C
kh
V
A
s
1
23
4
°C
kh
V
A
s
1
23
4
°C
kh
V
A
s
1
Press the Up Key ( ) and Down Key
( ) simultaneously for at least 3 s.
The display will return to the Mode
Selection Menu.
Press the Up Key ( ) twice to dis-
play RUN and then press the Mode
Key ( ) to change to Run Mode.
(If no keys are pressed within 5 s, the
S8M will automatically return to the
last operating mode.)
When Run Mode is entered, one of
the following will be displayed: input
voltage, current, run time, or internal
temperature.