Omron S8M - Page 97

79
Run Mode Section 5-4
Operations in Run
Mode
In Run Mode, the input voltage, the present current, and peak output current
for branch outputs 1 to 4, the total current, the run time, and the internal tem-
perature can be monitored regardless of the protection level. The peak output
currents can also be cleared. The display can be changed in the order shown
in the following table by pressing the Up Key ( ) or Down Key ( ).
❍ :Not lit
● :Lit
★ :Flashing
Note The procedure for clearing peak output currents is given next.
Clearing Peak Output
Currents
The peak output currents can be cleared. Clearing is possible in any protec-
tion level. The procedure for clearing the peak output current for branch output
1 is given below.
Display Output indicators Unit indicators Remarks
1234VAkh°Cs
Input voltage ❍❍❍❍● ❍❍❍❍---
Present current of branch output 1 ● ❍❍❍❍● ❍❍❍---
Peak output current of branch output 1
(See note.)
● ❍❍❍❍★❍❍❍---
Present current of branch output 2 ❍● ❍❍❍● ❍❍❍---
Peak output current of branch output 2 ❍● ❍❍❍★❍❍❍---
Present current of branch output 3 ❍❍● ❍❍● ❍❍❍---
Peak output current of branch output 3 ❍❍● ❍❍★ ❍❍❍---
Present current of branch output 4 ❍❍❍● ❍● ❍❍❍---
Peak output current of branch output 4 ❍❍❍● ❍★ ❍❍❍---
Total current of branch outputs 1 to 4 ●●●●❍●❍❍❍The total current
for branch outputs
1 to 4 is displayed.
Run time ❍❍❍❍❍❍● ❍❍---
Internal temperature ❍❍❍❍❍❍❍● ❍---
& 8
n o
Flashing
Flashin
g
23
4
°C
kh
V
A
s
1
23
4
°C
kh
V
A
s
1
Press the Up Key ( ) or Down
Key ( ) until the “A” unit indicator
flashes.
Press the Mode Key ( ). “NO”
will be displayed. Clearing is not
possible from this display, so press
the Up Key ( ) to change the dis-
play to “YES.”
(If no keys are pressed within 5 s,
the S8M will automatically return
to the last display.)