11
S8M Operating Procedure Section 1-4
1-4 S8M Operating Procedure
Using the S8M
Typical Startup Procedure Using the S8M's Keys
Typical Startup Procedure Using the Support Tool
Preparation
Installation and wiring
Power ON
Set parameters
Trial run in Test Mode
Verify operation
Actual operation
See Section 3 Installation and Wiring.
See Section 4 Initial Settings.
See Section 5 Trial Run.
Connect the branch outputs that will be
used and then switch to Run Mode.
Verify proper operation while monitoring status in Run Mode.
Note: When turning ON the power, setting parameters, and
testing operation in a new S8M, the parameter
settings will be saved only when the S8M is switched
to Run Mode.
Preparation
Installation and wiring
Power ON
Connect Support Tool
See Section 3 Installation and Wiring.
Set parameters
Trial run
Always connect the branch
outputs that will be used.
See Section 6 Support Tool.
Verify operation
Verify proper operation while
monitoring status.
Actual operation
To Next Page
Loading...