75
Test Mode Section 5-1
Operations and Displays in the Mode Selection Menu
r u
n
s e
t
t s
t
o n
Flashing
All OFF (not lit)
In a newly purchased S8M, no branch outputs are
connected, so none of the status indicators is lit.
23
4
°C
kh
V
A
s
1
23 41
23 41
23 41
23 41
23
4
°C
kh
V
A
s
1
23
4
°C
kh
V
A
s
1
23
4
°C
kh
V
A
s
1
If the S8M is switched to the Mode Selection Menu from
Run Mode, RUN will be displayed on the seven-seg-
ment display. If the S8M is switched to the Mode Selec-
tion Menu from Setting Mode, SET will be displayed on
the seven-segment display.
The S8M will enter Run Mode from this display if the
Mode Key ( ) is pressed. Also, the S8M will enter Run
Mode automatically if neither the Up Key ( ) nor Down
Key ( ) is pressed within 5 s.
If the Down Key ( ) is pressed, SET will be displayed.
At this point, the S8M will switch to Setting Mode if the
Mode Key ( ) is pressed.
If no keys are pressed within 5 s, the S8M will automati-
cally return to the last operating mode (Setting Mode if
the S8M is new). For details on parameter settings, refer
to SECTION 4 Parameter Settings.
If the Down Key ( ) is pressed, TST will be displayed.
At this point, the S8M will switch to Test Mode if the
Mode Key ( ) is pressed.
If no keys are pressed within 5 s, the S8M will automati-
cally return to the last operating mode (Setting Mode if
the S8M is new).
Press the Mode Key ( ) to change to Test Mode.
The flashing “on” display indicates that the S8M is ready
to connect branch output 1.
To Next Page
Loading...