9. Program
57
T
●Internal addresses
hese addresses are used to operate this program only.
Address Data type Symbol name Explanation
5000.01 BOOL Local_PMCRExecuting Indicates the PMCR instruction execution status.
PMCR instruction is
ted, and turns OFF when the PMCR
instruction is not executed.
This flag turns ON when the
being execu
5000.04 nd Turns ON when the PMCR instruction ends normally. BOOL Local_PMCRNormalE
500 orEnd Turns ON when a communications error (e.g.,
0.05 BOOL Local_PMCRErr
transmission error) occurs.
500 .06 BOOL Local_DestinationDeviceError Turns ON when a destination device error occurs. 0
5 Local_PMCRErrorCode Turns ON when any of the following PMCR instruction
errors occurs.
(1) Sequen
(3) Protocol macro syntax error
000.07 BOOL
ce No. error
(2) Data read/write area exceeded error
5 ocal_ControlWord1 Execution parameter of PMCR instruction. 010 UINT L
5 PMCR instruction. 011 UINT Local_ControlWord2 Execution parameter of
5 UIN Local_P e Stores the error cod CR instruction error
occurs.
012 T MCR_ErrorCod e when a PM
5020 U the INT Local_FirstSendWord Sets the number of send message words of
PMCR instruction.
5500 UINT Local_FirstReceiveWord the number of message words received from Stores
the destination device.
5501 UINT Local_ReceiveSymbolArea_Res
ponseCode
destination device when a
urs.
Stores the error code of a
destination device error occ
To Next Page
Loading...
Need help?
General
