Omron Sysmac NJ-series Connection Guide

7
．
EtherNet/IP Connection Procedure
15
7. EtherNet/IP Connection Procedure
This section describes the procedures for connecting Sensor Controller and Controller on the
EtherNet/IP network. The explanations of procedures for setting up Controller and Sensor
Controller given in this document are based on the factory default settings.
For the initialization, refer to Section 8. Initialization Method.
7.1. Work Flow
Take the following steps to operate tag data links by connecting Sensor Controller and
Controller via EtherNet/IP.
7.2. Sensor Controller Setup
Set up Sensor Controller.
↓
7.2.1. Hardware Settings Connect cables and others to Sensor Controller.
↓
7.2.2. Parameter Settings
Set the parameters for Sensor Controller.
↓
7.3. Controller Setup
Set up Controller.
↓
7.3.1. IP Address Settings
Set the IP address of Controller.
↓
7.3.2. Target Device Registration
Register the target device.
↓
7.3.3. Setting the Global Variables
Set the global variables to use for tag data links.
↓
7.3.4. Tag Registration
Register the tags and the tag sets.
↓
7.3.5. Setting the Connections
Set the target variables and the originator
variables, and then set the connections.
↓
7.3.6. Transferring the Project Data
Connect online and transfer the connection
settings and the project data to Controller.
↓
7.4. EtherNet/IP Communication Status
Check
Confirm that the EtherNet/IP tag data links operate
normally.
↓
7.4.1. Checking the Connection Status
Check the connection status of the EtherNet/IP
network.
↓
7.4.2. Checking the Sent and
Received Data
Check that the correct data are sent and received.

Omron Sysmac NJ-series Specifications

General

Brand	Omron
Model	Sysmac NJ-series
Category	Computer Hardware
Language	English