Omron V600 Series Operation Manual

ix
About this Manual:
This manual describes the installation and operation of the V600 RFID System with serial interface and
the ID Controller and includes the sections described below.
Please read this manual carefully and be sure you understand the information provided before attempting
to install and operate the V600 RFID System with serial interface and the ID Controller.
Section 1 provides a general introduction to the V600 RFID System with serial interface and the ID Con -
troller.
Section 2 provides the V600-CA1A-Vj/CA2A-Vj nomenclature and specifications as well as the
dimensions of both Units.
Section 3 provides procedures and formats required for communications with the host computer . A pro -
gram example is also provided.
Section 4 provides the commands and procedures required for Monitor Unit operations.
Section 5 provides installation and pre-operation setting procedures.
Section 6 provides diagnosis and maintenance procedures as well as solutions to possible problems and
abnormalities.
The Appendices contain information relating to standard models, ASCII codes, and Auto Read/Auto
Write operations.
WARNING Failure to read and understand the information provided in this manual may result in
personal injury or death, damage to the product, or product failure. Please read each
section
in its entirety and be sure you understand the information provided in the section
and related sections before attempting any of the procedures or operations given.
!

Omron V600 Series Specifications

General

Operating Frequency	13.56 MHz
Supported Standards	ISO 15693, ISO 18000-3
Read Range	Up to 70 mm (depending on tag and environment)
Power Supply	24 VDC ±10%
Operating Temperature	-10 to 55°C (with no icing or condensation)
Humidity	35% to 85% (non-condensing)
Communication Interface	RS-232C