Omron V600 Series Operation Manual

3-1SectionData Carrier Motion and Command Conditions
20
1, 2, 3... 1. Send a polling auto command to Unit 1 R/W Head 1.
2. The ID Controller Immediately receives the command and returns a
response indicating that it has received the command.
3. Send a polling auto command to Unit 2 R/W Head 2.
4. The ID Controller immediately receives the command and returns a
response indicating that it has received the command.
5. The
host computer can query the status of processing using subcommands
or suspend polling auto processing.
6. When the DC is not close to the specified R/W Head, a “not close” response
is returned in response to a query subcommand.
7. When a data carrier passes in front of Unit 1 R/W Head 1, write or read pro -
cessing is performed.
8. Once processing is completed, the ID Controller sends a response to the
host computer indicating that the processing indicated by the query sub-
command has been completed.

Omron V600 Series Specifications

General

Operating Frequency	13.56 MHz
Supported Standards	ISO 15693, ISO 18000-3
Read Range	Up to 70 mm (depending on tag and environment)
Power Supply	24 VDC ±10%
Operating Temperature	-10 to 55°C (with no icing or condensation)
Humidity	35% to 85% (non-condensing)
Communication Interface	RS-232C