114
SECTION 5
V680 Commands
RFID System
User’s Manual
SECTION 5
Communications
Controller Control Commands
The controller control commands are used to set communication parameters or when resending the
response.
Host Commands
The following commands are used to control the ID Controller.
Evaluation Command
The following command is used to check ambient noise.
Command
code
Name Description Page
US UID ADDITION SET Sets whether or not UID should be added to the read command (RD)
response.
p. 144
TR COMMUNICATIONS SET Sets serial communications parameters for communicating with the
host device.
p. 145
SP PARAMETER SET Sets, reads, or initializes ID Controller parameters. p. 147
MO OPERATION MODE CHANGE Changes the operation mode. p. 151
SE OPERATION CONDITION SET Sets operation conditions for Self Execution Mode. p. 153
RR RESPONSE RESEND Resends the last response that was sent. p. 159
CC CONTROLLER CONTROL Controls or confirms ID Controller I/O. p. 160
CF READ ERROR INFORMATION Reads the error log. p. 162
HI READ HISTORY INFORMATION Reads the ID Controller's history information. p. 164
Command
code
Name Description Page
TS TEST Checks the communications conditions between the ID Controller and
host device. The data sent by the host device is returned by the ID
Controller without modification.
p. 166
VS VERSION READ Read the software version of the ID Controller. p. 167
Command
code
Name Description Page
NS NOISE DETECTION Measures noise under normal conditions. The ID Controller returns
the noise level as the results of the measurement.
p. 168
To Next Page
Loading...
