214
SECTION 5
V600 Commands
RFID System
User’s Manual
SECTION 5
Communications
Query/cancel designation Specifies querying or canceling polling auto processing.
“C”: Processing results query
“E”: Processing results cancel
Antenna designation Specifies the Antenna for querying or canceling.
“1”: Antenna 1
“2”: Antenna 2
End code Indicates the execution result for the command.
“00”: Normal end
“74”: No Tag has approached when polling auto processing results were requested.
“75”: No Tag has approached when polling auto processing was cancelled.
“76”: Communications processing was in progress or completed when polling auto processing
was cancelled.
Refer to List of End Codes for information on other end codes.
p. 235
PW
C/E 1/2
2
2
* CR
Query/cancel designation
Antenna designation
11
2
FCS
3
@
Command
code
Terminator
Controller No.
××
××
Subcommand
Subcommand Response
PW
00
22
2
* CR
2
FCS
3
@
Command
code
Terminator
End code
Controller No.
×
×
×
×
To Next Page
