Omron V680-CA5D01-V2

221
RFID System
User’s Manual
SECTION 5
V600 Commands
SECTION 5
Communications
Communications Subcommands
Communications subcommands are used in combination with commands for Tag communications.
They cannot be used by themselves to communicate with a Tag.
 COMMAND PROCESSING TERMINATE (AA)
The COMMAND PROCESSING TERMINATE command cancels any command except for polling
commands and returns the ID Control to command standby status. This command can also be used to
cancel communications for expansion commands with divided frames before completion of the expan-
sion command.
 1:1 Protocol
 1:N Protocol
End code Indicates the execution result for the command.
14: No automatic or normal commands being processed.
75: Processing terminated before a Tag was detected.
76: Processing terminated while reading from or writing to a Tag.
Refer to List of End Codes for information on other end codes.
p. 235
End code Indicates the execution result for the command.
14: No automatic or normal commands being processed.
75: Processing terminated before a Tag was detected.
76: Processing terminated while reading from or writing to a Tag.
Refer to List of End Codes for information on other end codes.
p. 235
Command
AA
2
2
*
CR
Command
code
Terminator
Response
AA
22
2
* CR
Command
code
Terminator
End code
×
×
Command
AA
2
2
*
CR
2
FCS
3
@
Command
code
Terminator
Controller No.
×
×
×
×
Response
AA
22
2
*
CR
2
FCS
3
@
Command
code
Terminator
End code
Controller No.
×
×
×
×
×
×