Omron V680-CA5D01-V2 - Page 225

222
SECTION 5
V600 Commands
RFID System
User’s Manual
SECTION 5
Communications
 ABORT (XZ)
The ABORT command can be used to reset the ID Controller to command standby status during com-
munications with the host device or a Tag if any sort of trouble occurs, e.g., if the ID Controller does not
return a response. The ID Controller does not return a response to the ABORT command.
 1:1 Protocol
About 100 ms is required after the ID Controller receives the ABORT command before it can receive the next command.
 1:N Protocol
About 100 ms is required after the ID Controller receives the ABORT command before it can receive the next command.
Command
XZ
2
2
* CR
Command
code
Terminator
Command
XZ
2
2
* CR
2
FCS
3
@
Command
code
Terminator
Controller No.
×
×
×
×