78
SECTION 3
Trial Operation
RFID System
User’s Manual
SECTION 3
Preparations for Communications
Communications Test between Tags and the Antenna
Actual commands can be sent from the host device to test whether communications between Tags and
the Antenna are normal.
1. Send a READ command (communications designation “SA”) from the host device.
For details on the READ command, refer to READ (RD).
p. 116
2. Position a Tag near the Antenna communications surface.
The Controller will read the Tag data once the Tag enters the Antenna's communications area. An error
code will be displayed on the monitor display if communications are not successful.
If the end code “00” is not displayed on the monitor display, check List of End Codes and correct the error.
p. 171
To Next Page
Loading...
Need help?
General
