Onkyo DR-UN7 User Manual

45
Listening to the Radio —Continued
Selecting XM Radio Channels
There are two modes for selecting XM radio channels:
Channel Search mode , which allows you to select any
channel.
Category Search mode , which allows you to select
channels by category.
Use the remote controller to select XM radio channels.
■ Channel Search Mode
Note:
Channels cannot be selected while the indicator
is flashing, as tuning is in progress.
■ Category Search Mode
Note:
Channels cannot be selected while the indicator
is flashing, as tuning is in progress.
Selecting the Previous Channel:
To listen to the previously selected XM channel.
1
Press INPUT / to select XM.
If “Antenna” appears on the display,
make sure the XM antenna is connected
properly.
2
Press MODE to select “Channel
Search” mode.
3
Use TUNING / to select a
channel and you can also use /
(cursor) to select a category.
1
3
2
3
and
Channel nameChannel number
1
Press INPUT / to select XM.
If “Antenna” appears on the display,
make sure the XM antenna is connected
properly.
2
Press MODE to select “Category
Search” mode.
3
Use / (cursor) to select a cat-
egory, and use / (cursor) to
select a channel in that category.
1
Press RETURN button.

Onkyo DR-UN7 Specifications

Power

power supply	AC 120 V, 60 Hz
power consumption	115 W
stand-by power consumption	0.2 W

Operating Environment

operating temperature	5 ˚C–35 ˚C
operating humidity	5 %–85 %
tuning frequency range	87.5 MHz–107.9 MHz

Audio Specifications

signal to noise ratio	100 dB (LINE, IHF-A)
frequency response	10 Hz–100 kHz/±3 dB (LINE)
total harmonic distortion	5 % (Power Rated)

Weight and Dimensions

dimensions	205 W x 147 H x 353 D mm
weight	5.4 kg