11
Remote controller
+
–
CH
VOL
MUTE
CONT
+
–
LIGHT
AV Amp
(Page 1/3)
(Page 2/3)
For details on how to use the remote controller, refer to “Using
the remote controller” (page 61).
Select AV Amp in the Home menu to display the operation buttons.
MUTE button
Activates the mute function. [53]
CH +/– button
When AV Amp is selected, for selecting a tuner preset channel. [50]
VOL / buttons
When AV Amp is selected, for adjusting the volume. When Zone 2
is selected, for adjusting the volume in the Zone 2.
First operation menu (page 1/3)
ON button
Turns on the TX-DS898.
OFF button
Places the TX-DS898 in the standby state.
LISTEN button
For displaying listening mode buttons.
STEUP button
For displaying setup operation buttons.
Input Selector buttons
Select an input source.
CD: CD, DVD: DVD, Tuner: FM/AM, Phono: PHONO, Tape1: TAPE,
Tape2: Not used with the TX-DS898, Video1: VIDEO 1, Video2:VIDEO
2, Video3:VIDEO 3, Video4:VIDEO 4, Video5: VIDEO 5
Audio Sel button
For selecting the audio input signal. The setting changes from
“Auto” to “Multich” to “Analog” and back each time this button is
pressed. [56]
Second operation menu (page 2/3)
Listening mode buttons
Direct: Changes the listening mode directly to the Direct listening
mode. If pressed, the listening mode for the selected input source set
in the Listening Mode Preset is also changed to the Direct listening
mode. When the listening mode is set to Direct, you can switch
between Direct and Pure Audio.
Stereo: Changes the listening mode directly to the Stereo listening
mode. If pressed, the listening mode for the selected input source set
in the Listening Mode Preset sub-menu is also changed to the Stereo
listening mode.
Surr: Changes the listening mode to the surround mode for the
current input signal (e.g., Dolby Pro Logic II, Dolby Digital, or
DTS). If pressed, the listening mode for the selected input source set
in the Listening Mode Preset is also changed to the Surround
listening mode.
When the Surround listening mode is selected
• When playing back DTS sources
Switches the DTS-ES setting from Auto → On → Off.
• When playing back Analog/PCM sources
Switches from Pro Logic II Movie → Pro Logic II Music →
DTS Neo6:Cinema → DTS Neo6:Music.
• When playing back D.F. 2-channel sources
Switches from Pro Logic II Movie → Pro Logic II Music.
To Next Page
Loading...
Need help?
General
