Basic Operations—Continued
26
Using Headphones
Turn down the volume, then connect your stereo
headphones to the [PHONES] minijack.
You can adjust the volume and mute the sound, by
using the [VOLUME] control.
The speakers output no sound while the headphones
are connected.
When you select iPod as the input source, the
headphones output no sound. If use headphones,
connect it directly to iPod/iPhone.
Muting the Sound
To mute the output of the stereo receiver,
press the remote controller’s [MUTING]
button. The MUTING indicator flash on
the display.
To unmute the stereo receiver, press the
[MUTING] button again.
While the stereo receiver is muted:
• Turning the [VOLUME] control on the stereo receiver
or pressing the VOLUME [ ]/[ ] buttons on the
remote controller will unmute the stereo receiver.
• If you turn the stereo receiver off, the next time you
turn it on, the stereo receiver will be unmuted.
Adjusting the Bass, Treble and
Balance
You can adjust the bass, treble and balance using the
selector on the front panel.
The Default setting is “0”. You can adjust the bass and
treble from -6 to +6, and the balance from L6 to R6.
Using the Direct Function
To turn the Direct function on or off, press
the [DIRECT] button on the stereo
receiver. When the Direct function is off,
the tone controls can be used to adjust the
sound. When the Direct function is on, the
tone controls are bypassed, so you can
enjoy a pure sound, and the DIRECT LED
lights up.
To Next Page
Loading...
Need help?
General
