• You must set the clock before you can program the
timers.
• Before programming a timer to turn on the radio,
you must preset the station you want to use. (See
pages 48 to 49.)
• If you don’t operate any buttons for 60 seconds
while programming a timer, the procedure will be
cancelled and the previous display will reappear.
1
Press the [TIMER] button repeatedly
to select Timer 1, 2, 3, or 4, and then
press [ ].
If “Clock” appears, you need to set the
clock (see pages 23, 55 to 56).
2
Use the Previous and Next [ ]/
[ ] buttons to select the source,
and then press [ ].
3
If you selected “FM”, “AM” or “DAB”
(R-1045DAB only), use the Previous
and Next [ ]/[ ] buttons to select
the radio preset, and then press [ ].
You can select the following source;
R-1045DAB
R-1045
4
Use the Previous and Next [ ]/
[ ] buttons to select “Once” or
“Every”, and then press [ ].
Select “Once” for on-off operation.
Select “Every” to perform the same
operation every week.
5
If you selected “Once”, use the
Previous and Next [ ]/[ ]
buttons to select the day, and then
press [ ].
You can select: SUN, MON, TUE, WED,
THU, FRI, or SAT.
Go to step 8.
6
If you selected “Every”, use the
Previous and Next [ ]/[ ]
buttons to select the day,
“Everyday” or “Days Set”, and then
press [ ].
You can select the following:
To Next Page
Loading...
Need help?
General
