Using the Timers—Continued
59
To return to step 1 and start timer programming all over
again, press the [MENU/NO] button at any point in this
procedure.
7
If you selected “Days Set”, use the
Previous and Next [ ]/[ ]
buttons to select the first day, and
then press [ ].
Use the Previous and Next [ ]/
[ ] buttons again to select the last
day, and then press [ ].
You can select only consecutive days.
8
Use the Previous and Next [ ]/
[ ] buttons to specify the On time,
and then press [ ].
You can also use the remote controller’s
number buttons to enter the time. For
example, to enter 7:29, press [7], [2], and
[9].
• Once the On time is set, the Off time is
automatically set to one hour later.
9
Use the Previous and Next [ ]/
[ ] buttons to specify the Off time,
and then press [ ].
10
If you selected “Play” in step 2, Use
the Previous and Next [ ]/[ ]
buttons to specify the stereo
receiver’s volume level, and then
press [ ].
The default setting is “10”.
If you want to use your normal volume
level setting for the timer, press the
Previous button repeatedly until
“TimerVol.Lst” appears on the display.
In this case, the timer will use the volume
level that was set before the stereo receiver
was set to Standby.
11
TIMER indicator 1, 2, 3, or 4 will stop
flashing and light up.
Press the [ON/STANDBY] button to
set the stereo receiver to Standby.
• Be sure to set the stereo receiver to
Standby, otherwise the timed operation
will not work.
• While a timed operation is in progress,
you can cancel it by pressing the
[TIMER] or [SLEEP] button.
• Memory, random, and 1-Folder (USB
only) playback cannot be used with the
timers.
TIMER indicator
Number of programmed timer
To Next Page
Loading...
Need help?
General
