• If the remote controller doesn’t work reliably, try
replacing the batteries.
• Don’t mix new and old batteries or different types of
batteries.
• If you intend not to use the remote controller for a
long time, remove the batteries to prevent damage
from leakage or corrosion.
• Expired batteries should be removed as soon as
possible to prevent damage from leakage or
corrosion.
Using the Remote Controller
When you operate the remote controller, point it at the
stereo receiver’s remote control sensor, as shown
below.
Notes
• The remote controller may not work reliably if the
stereo receiver and the CD Player are subjected to
bright light, such as direct sunlight or inverter-type
fluorescent lights. Keep this in mind when installing.
• If another remote controller of the same type is used
in the same room, or the stereo receiver is installed
close to equipment that uses infrared rays, the
remote controller may not work reliably.
• Don’t put anything, such as a book, on the remote
controller because the buttons may be pressed
inadvertently, thereby draining the batteries.
• The remote controller may not work reliably if the
stereo receiver and the CD Player are installed in a
rack behind colored glass doors. Keep this in mind
when installing.
• The remote controller will not work if there’s an
obstacle between it and the stereo receiver and CD
Player’s remote control sensor.
• The CD Player cannot be controlled using the remote
controller without connecting to the stereo receiver
via the cable.
1
To open the battery compartment,
press the small hollow and slide
open the cover.
2
Insert two batteries (R03/AAA) into
the compartment.
Carefully follow the polarity diagram
(positive (+) and negative (–) symbols)
inside the battery compartment.
The battery is not supplied with products
for China.
3
Slide the cover shut.
A
p
p
r
o
x
.
5
m
(
1
6
f
t
.
)
Remote control sensor
To Next Page
Loading...
Need help?
General
