Update Notice
Default Value: Enable
Availability of a firmware update will be notified via network.
"Enable": Notify updates
"Disable": Do not notify updates
Version
Default Value: –
The current firmware version will be displayed.
Update via NET
Default Value: –
Press ENTER to select when you want to update the firmware via
network.
You will not be able to select this setting if you do not have Internet
access or there is nothing to update.
Update via USB
Default Value: –
Press ENTER to select when you want to update the firmware via USB.
You will not be able to select this setting if a USB storage device is
not connected or there is nothing to update in the USB storage
device.
Wait for a while if "Firmware Update" cannot be selected. It will appear
when the network function is started up.
Initial Setup
You can make the initial setup from the setup menu.
Wait for a while if "Initial Setup" cannot be selected. It will appear when
the network function is started up.
Setting is not possible if "Monitor Out" is set to "SUB".
To Next Page
Loading...
