7.Hardware Setup
Multi Zone
Zone 2 Out
Default Value: Fixed
Select which of the integrated amplifier in a separate room or this unit
should be used to adjust the volume when Zone 2 is active.
"Fixed": Adjust on the Integrated amplifier in a separate room
"Variable": Adjust on the unit
Zone 2 Maximum Volume
Default Value: Off
Set the maximum value for Zone 2 to avoid too high volume. Select a
value from "Off", "50" to "99".
Zone 2 Power On Volume
Default Value: Last
Set the Zone 2 volume level of when the unit is turned on. Select a
value from "Last" (Volume level when the unit was turned off), "Min", "1"
to "99" and "Max".
You cannot set a higher value than that of "Zone 2 Maximum
Volume".
Zone 3 Out
Default Value: Fixed
Select which of the integrated amplifier in a separate room or this unit
should be used to adjust the volume when Zone 3 is active.
"Fixed": Adjust on the Integrated amplifier in a separate room
"Variable": Adjust on the unit
Zone 3 Maximum Volume
To Next Page
Loading...
