8.Remote Controller Setup
Remote ID
Default Value: 1
Select an ID for the unit's remote controller from "1", "2", and "3" to
prevent interference between the unit and other Onkyo components that
are installed in the same room. After changing the ID on the main unit,
change the ID on the remote controller accordingly with the following
procedure.
1. While holding down RCV, press Q SETUP for about 3 seconds until
the remote indicator lights.
2. With the number buttons, press one of 1, 2, and 3. The remote
indicator flashes twice.
Remote Mode Setup
Default Value: –
Input and register the remote controller code of other devices.
For registration of the remote control code, refer to "Operating Other
Components with the Remote Controller".
To Next Page
Loading...
