You can enable the control functions between the unit and external devices
using the terminals below. Special devices or cable connections are
necessary to enable the functions. For more information about preparation,
contact the specialized stores.
RS232 port
Use the port for connection with a commercially available integrated control
system that can enable home automation. Some integrated control systems
provide a centralized operation with a single touch panel controller in order to
control audio and video home appliances and security devices together. For
more information about adopting an integrated control system, contact the
specialized stores.
IR jack
If you use a multiroom remote control kit such as Xantech and Niles with this
jack, you can operate the unit with the remote controller even when you are
in a separate room, or operate the unit with the remote controller even if its
remote control sensor is difficult to see. For more information about adopting
a multiroom remote control kit, contact the specialized stores.
12V trigger output jack
You can enable power link operation when you connect the unit and an
external device such as power amplifier equipped with 12V trigger input jack.
When the Zone 2 function of the unit is turned on, the power link operation
will be activated with a control signal of maximum 12V/150mA output from the
12V trigger output jack. For connection, use a monaural mini plug cable.
To Next Page
Loading...
