Video
There is no picture
Make sure that all video connecting plugs are pushed in all the way.
Make sure that each video component is properly connected.
If the TV is connected to the HDMI OUT jack of the unit, set "Monitor Out"
to "MAIN" or "SUB" according to the output jack. If the playback source is
connected to the video (composite) jack or component video jacks and
you want to output the video to the TV via the HDMI OUT jack, set "HDMI
Input" to "-----".
If the video source is connected to a component video input, you must
assign that input to an input selector, and your TV must be connected to
COMPONENT VIDEO OUT terminal.
If the video source is connected to a composite video input, your TV must
be connected to the MONITOR OUT V terminal.
If the video source is connected to an HDMI input, you must assign that
input to an input selector, and your TV must be connected to the HDMI
output(s).
While the Pure Audio listening mode is selected, the analog video circuitry
is turned off and only video signals input through HDMI IN can be output.
Make sure the switching of input screens is proper at the monitor side
such as a TV.
When the image input from the composite video input terminal does not
get displayed, make sure that the component video input terminal is not
set to the selected input. If selected, images input from the composite
video input terminal cannot be output to this input switching. If only
composite video input terminal connection is used, set the component
video input terminal to "----- ."
Images of a component connected to the composite video input terminal
cannot be output by converting on the monitor of a TV or other
components connected to COMPONENT VIDEO OUT terminal.
If the input selector to which the input from the TV connected to the HDMI
OUT SUB jack is connected is changed on this unit when "Monitor Out" is
set to "MAIN+SUB", or "MAIN" and when outputting to Zone 2, the video
from the TV connected to HDMI OUT MAIN stops displaying.
"Resolution" is effective only for the HDMI OUT MAIN jack if "Monitor Out"
is set to "MAIN+SUB".
There is no picture from a source connected to an HDMI IN
Reliable operation with an HDMI-to-DVI adapter is not guaranteed. In
addition, video signals from a PC are not supported.
To Next Page
Loading...
