In the following cases, the setting will be set to "None":
– "Surround" is set to "None".
– "Front Speakers Type" is set to "Bi-Amp".
– "Powered Zone 2" is set to "Yes" and also Zone2 is set to on.
"Full Band" cannot be set unless "Front" is set to "Full Band".
LPF of LFE
Default Value: 120Hz
Set the low-pass filter for LFE (low-frequency effect) signals in order to
pass lower frequency signals than the set value and thus cancel
unwanted noises. The low-pass filter will be effective only on sources
with LFE channel.
Select a value between "80Hz" to "120Hz".
"Off": Do not use this function
Subwoofer Phase
Default Value: 0°
Switch the phase of subwoofer between "0°" and "180°".
Double Bass
Default Value: -----
Boost bass output by feeding bass sounds from the front left and right,
and center speakers to the subwoofer.
"On": Bass output will be boosted.
"Off(THX)": Bass output will not be boosted.
The setting will not automatically be configured even if you
performed the automatic speaker setup.
If "Subwoofer" is set to "No" or if "Front" is set to other than "Full
Band", the setting will be fixed to "-----".
If you're using THX-certified speakers, we recommend the following
settings:
– Set a value "80Hz(THX)" in Crossover frequency.
– Set a value "80Hz(THX)" in LPF of LFE.
– Set a value "Off(THX)" in Double Bass.
Speaker Distance
Set the distance from each speaker to the listening position. Settings are
automatically configured if you use the automatic speaker setup.
To Next Page
Loading...
