Onkyo TX-RZ3100 - Page 28

Setthemaximumvaluetoavoidtoohighvolume.Selectavaluefrom"Off",
"50"to"99".(When"VolumeDisplay"issetto"Absolute")
PowerOnVolume
DefaultValue:Last
Setthevolumelevelofwhenthepoweristurnedon.Selectavaluefrom
"Last"(Volumelevelbeforeenteringstandbymode),"Min","0.5"to"99.5"
and"Max".(When"VolumeDisplay"issetto"Absolute")
Youcannotsetahighervaluethanthatof"MaximumVolume".
HeadphoneLevel
DefaultValue:0.0dB
Adjusttheoutputleveloftheheadphones.Selectavaluebetween"－12.0
dB"and"＋12.0dB".
4.Source
Makesettingsforinputsources,suchasvolumedifferenceadjustmentsforeach
inputselectorfortheconnectedequipment.
1.IntelliVolume
Adjustthevolumeleveldifferencebetweenthedevicesconnectedtotheunit.
Selecttheinputselectortoconfigure.
IntelliVolume
DefaultValue:0.0dB
Selectavaluebetween"－12.0dB"and"＋12.0dB".Setanegativevalueif
thevolumeofthetargetdeviceislargerthantheothersandapositivevalue
ifsmaller.Tochecktheaudio,startplaybackoftheconnecteddevice.
ThisfunctionisnoteffectiveinZone2/Zone3.
2.NameEdit
Setaneasynametoeachinput.Thesetnamewillbeshownonthemainunit
display.Selecttheinputselectortoconfigure.
NameEdit
DefaultValue:Inputname
1. SelectacharacterorsymbolwiththecursorsandpressENTER.
Repeatittoinput10orlesscharacters.
"A/a":Switchesbetweenupperandlowercases.(PressingMODEonthe
remotecontrolleralsotogglesbetweenupperandlowercases)
"←""→":Movesthecursortothearrowdirection.
" ":Removesacharacterontheleftofthecursor.
" ":Entersaspace.
PressingCLRontheremotecontrollerwillremovealltheinput
characters.