Onkyo TX-RZ70 - Connecting an Integrated Amplifier (ZONE 3)

73
Connections
Connecting an Integrated Amplier (ZONE 3)
You can enjoy 2 ch audio in the separate room (ZONE 3) while performing
playback in the main room (where this unit is located). Use an analog audio
cable to connect the ZONE 3 PRE/LINE OUT jack on this unit to the input jack
on an integrated amplier in the separate room. The same source can be played
back in the main room and ZONE 3 simultaneously. Also, di󰀨erent sources can
be played back in both rooms.
• To output audio from an externally connected AV component to ZONE 3,
use an analog audio cable for connection. Note that ZONE 3 output is not
possible with the connection using a HDMI cable, digital coaxial cable, or
digital optical cable.
Setup
• With speaker combinations ( →p204) 2.1.2 ch, 3.1.2 ch, 4.1.2 ch, or
5.1.2 ch, this function cannot be used when using Bi-AMP or ZONE 2 (ZONE
SPEAKER).
• When connecting an integrated amplier that has an external volume control,
set "Multi Zone" - "Zone 3" - "Output Level" ( →p158) to " Fixed (Default
Value)" on the Setup menu. If your external integrated amplier does not have
an external volume control please set this at "Variable". If you do not set this,
the volume output will be very loud and there is a danger of damage to the
integrated amplier, speakers, etc.
Note
• ZONE 3 PRE/LINE OUT cannot be used when the connected speaker
conguration is "6.1 ch", "7.1 ch", "6.1.2 ch", "7.1.2 ch", "4.1.4 ch", "5.1.4 ch",
"6.1.4 ch", or "7.1.4 ch".
Input
Terminal
a
Integrated
amplier
a Analog audio cable
BD/DVD
 Multi-zone ( →p107)
 Playing Back (ZONE 3) ( →p110)