Onkyo TX-RZ70 - Connecting a transmitter for playback

123
Playback
Connecting a transmitter for playback
When you connect wireless headphones or a wireless speaker transmitter to the ZONE B LINE OUT jacks of this unit, you can play back the same source through the
wireless headphones or wireless speakers as in the main room.
Connections
1. Use an analog audio cable to connect the ZONE B LINE OUT jacks on this
unit to the input terminal on the transmitter.
OR
Transmitter
Setting Up
1. Press on the remote controller, and set "Speaker" - "Conguration" - "Zone
2 Preout" to "Zone B". ( →p134)
Playing Back
1. Press the Q button on the remote controller and select "Audio" - "Zone B".
• In the following cases, "Zone B" cannot be selected.
– When ZONE 2 is On
– When "Speaker" - "Conguration" - "Zone 2 Preout" on the Setup menu
is set to "Zone 2". ( →p134)
2. Select the audio output destination.
O󰀨: Outputs audio only from ZONE A. "A" on the display of the main unit
lights up.
On (A+B): Outputs audio from both ZONE A and ZONE B. "A" and "B" on the
display of the main unit light up.
On (B): Outputs audio only from ZONE B. "B" on the display of the main unit
lights up.
3. Start play on the AV component.
4. Adjust the volume on the transmitter, etc., in ZONE B.
• When "Zone 2 Preout" is set to "Zone B", and "Audio" - "Zone B" on the Quick
Menu is set to "On (A+B)", the ZONE A output is set as below.
– When the sound quality is adjusted with the TONE button, the sound
quality changes in both ZONE A and ZONE B.
– There will be no e󰀨ect for the surround back speakers from "Speaker" -
"Distance" ( →p137) in the Setup menu.
a
a Analog audio cable