Onkyo TX-RZ70 - Page 134

134
SetupSetup
2. Speaker
 Height 2 Speaker (Default Value: Top Rear)
Set the speaker type if height speakers are connected to the HEIGHT 2
terminals.
Select "Front High", "Top Front", "Top Middle", "Top Rear", "Rear High", "Dolby
Speaker (Front)", "Dolby Speaker (Surr)" or "Dolby Speaker (Back)" according
to the type and layout of the connected speakers. However, the options
selectable for the "Height 1 Speaker" are as follows.
– If "Height 1 Speaker" is set to "Front High": Select from "Top Middle", "Top
Rear", "Rear High", "Dolby Speaker (Surr)" or "Dolby Speaker (Back)".
– If "Height 1 Speaker" is set to "Top Front" or "Dolby Speaker (Front)":
Select from "Top Rear", "Rear High", "Dolby Speaker (Surr)" or "Dolby
Speaker (Back)".
– If "Height 1 Speaker" is set to "Top Middle": Fixed to "Rear High".
• "Dolby Speaker (Surr)" and "Dolby Speaker (Back)" can only be selected
when surround speakers or surround back speakers are being used,
respectively. You can check speakers that you are using on the gure
displayed in "Speaker Channels".
• If an item cannot be selected even though connection is correct, check
that the settings in "Speaker Channels" matches the number of connected
channels.
 Zone Speaker (Default Value: No)
Set whether ZONE 2 speakers and ZONE 3 speakers are being used.
• This setting cannot be selected when "Zone 2 Preout" is set to "Zone B".
No When neither ZONE 2 speakers nor ZONE 3 speakers are
used
Zone 2 When ZONE 2 speakers are used
Zone 2/Zone 3 When both ZONE 2 speakers and ZONE 3 speakers are used
• This cannot be selected when 2 sets of height speakers are
used.
 Zone 2 Preout (Default Value: Zone 2)
Set an output destination of the audio output from ZONE 2 PRE/LINE OUT/
ZONE B LINE OUT jack.
• This setting is xed to "Zone 2" when "Zone Speaker" is set to "Zone 2" or
"Zone 2/Zone 3".
Zone 2 When connecting an integrated amplier in a separate room
(ZONE 2)
Zone B When connecting an integrated amplier, transmitter of
wireless headphones, etc. to ZONE B
 Bi-Amp (Default Value: No)
Set whether the speakers are bi-amp connected.
• You cannot select a setting other than "No" or "Front" when using ZONE
speakers.
No When no speakers are bi-amp connected
Front When only front speakers are bi-amp connected
• This setting cannot be selected under the following
conditions.
– "Speaker Channels" is set to "6.1.4 ch" or "7.1.4 ch"
– "Speaker Channels" is set to "6.1.2 ch", "7.1.2 ch", "4.1.4
ch", or "5.1.4 ch" and "Zone Speaker" is set to "Zone 2" or
"Zone 2/Zone 3"
– "Speaker Channels" is set to "6.1 ch", "7.1 ch", or "2.1.2 ch"
to "5.1.2 ch" and "Zone Speaker" is set to "Zone 2/Zone 3"
Front/Center When front speakers and the center speaker are bi-amp
connected
This can only be selected when you have set "Speaker
Channels" to "3.1 ch", "5.1 ch", or "7.1 ch".