135
SetupSetup
2. Speaker
Speaker Impedance (Default Value: 6 ohms or above)
Set the impedance (Ω) of the connected speakers.
• For impedance, check the indications on the back of the speakers or their
instruction manual.
4ohms When any of the connected speakers have 4 Ω or more to less
than 6 Ω impedance
6 ohms or above
When all the connected speakers have an impedance of 6 Ω
or more
2. Crossover
Set what number of Hz in the low frequency range is output from each speaker
and what should be output from the subwoofer. When a subwoofer is not to be
used, set to "Full Band" so that the bass is output from the speakers.
• When Dirac Live Bass Control ( →p170) is used, the crossover frequency
setting made here is not available. Set using Onkyo Controller ( →p169).
Dirac Live Bass Control (Default Value: O)
Use the Dirac Live Bass Control to adjust the crossover frequency.
On When using Dirac Live Bass Control. This can be selected
when Dirac Live Bass Control measurements are performed.
O When this function is to not be used
Crossover Type (Default Value: Normal)
Set the crossover frequency to suit the speakers.
Klipsch When Klipsch speakers are used. The crossover that is
optimum for the speakers selected in Speaker Combo
( →p141) is applied. In this case, the crossover for each
speaker cannot be changed.
Normal When other than Klipsch speakers are used
Front (Default Value: 80 Hz (THX))
Center (Default Value: 80 Hz (THX))
Height 1 (Default Value: 80 Hz (THX))
Height 2 (Default Value: 80 Hz (THX))
Surround (Default Value: 80 Hz (THX))
Surround Back (Default Value: 80 Hz (THX))
LPF of LFE (Default Value: 120 Hz)
Double Bass (Default Value: On)
• As for the THX-certied speakers, the following settings are recommended.
– Crossover frequency → "80 Hz(THX)"
– "LPF of LFE" → "80 Hz"
– "Double Bass" → "O"
• This setting is disabled when the IMAX sound mode has been applied.
To Next Page
Loading...
