98
Zone 2—Continued
If you’ve connected your Zone 2 speakers to the AV
receiver/AV amplifier, as explained in “Connecting Your
Zone 2 Speakers Directly to the AV receiver/AV ampli-
fier” on page 97, you must set the “Powered Zone2” set-
ting to “Act” (Activated).
Notes:
• When “Act” is selected and Zone 2 turned on, the
Zone 2 speakers connected to the ZONE 2 L/R
speaker terminals output sound, but the surround back
speakers connected to the SURR BACK L/R speaker
terminals do not. When “Act” is selected and Zone 2
turned off, the surround back speakers output sound as
normal.
• Powered Zone2 cannot be used if “Speakers Type” is
set to “Bi-Amp” (see page 45).
• This procedure can also be performed on the AV
receiver/AV amplifier by using its [SETUP] button,
arrow buttons, and [ENTER] button.
Setting the Powered Zone 2
1
Press the [RECEIVER] button fol-
lowed by the [SETUP] button.
The main menu appears onscreen.
If the main menu doesn’t appear, make
sure the appropriate external input is
selected on your TV.
2
Use the Up and Down [q]/[w] but-
tons to select “7. Hardware
Setup”, and then press [ENTER].
The “Hardware Setup” menu appears.
3
Use the Up and Down [q]/[w] but-
tons to select “2. Zone2”, and
then press [ENTER].
The “Zone2” menu appears.
7. Hardware Setup
1. Remote Control
2. Zone2
3. Tuner
4. Analog Multich
5. HDMI
7–2. Zone2
Powered Zone2 Not Act
4
Use the Up and Down [q]/[w] but-
tons to select “Powered Zone2”,
and use the Left and Right [e]/
[r] buttons to select:
Not Act:
ZONE 2 L/R speaker terminals not
activated (Powered Zone 2 dis-
abled).
Act:
ZONE 2 L/R speaker terminals
activated (Powered Zone 2
enabled).
5
Press the [SETUP] button.
The setup menu closes.
To Next Page
Loading...
