Onkyo TX-SR602 - Schematic Diagram 6: Power Supply Section (Part 1)

19
Remote Controller —Continued
M
FR & FF [ ]/[ ] buttons
The FR [ ] button is used to start fast reverse. The
FF [ ] button is used to start fast forward.
N
Stop [ ] button
This button is used to stop playback.
O
RANDOM button
This button is used with the random playback func-
tion.
P
MEMORY button
This button is used with the memory playback func-
tion, which allows you to create a custom playlist of
tracks.
TAPE mode is used to control an Onkyo cassette
recorder connected to the AV receiver via .
To set the remote controller to TAPE mode, press the
[TAPE] REMOTE MODE button.
For double cassette decks, only Deck B can be con-
trolled.
1
Play [ ] button
This button is used to start playback.
2
Previous & Next [ ]/[ ] buttons
The Previous [ ] button is used to select the pre-
vious track. During playback it selects the begin-
ning of the current track. The Next [ ] button is
used to select the next track.
The Previous and Next [ ]/[ ] buttons may not
work properly with some cassette tapes depending
on how they were recorded.
3
Reverse Play [ ] button
This button is used to start reverse playback.
4
REC [ ] button
This button is used to start recording.
5
VOL button
This button is used to adjust the volume of the AV
receiver.
6
MUTING button
This button is used to mute the AV receiver.
7
Rewind & FF [ ]/[ ] buttons
The Rewind [ ] button is used to start rewind. The
FF [ ] button is used to start fast forward.
8
Stop [ ] button
This button is used to stop playback.
TAPE Mode
TX-NR702,602En.book Page 19 Tuesday, September 7, 2004 1:18 PM