55
Basic Operation
—Continued
You can display various information about the current
input source as follows.
The following information can typically be displayed for
input sources.
*If the input signal is analog, no format information is
displayed. If the input signal is PCM, the sampling fre-
quency is displayed. If the input signal is digital but not
PCM, the signal format is displayed. Information is dis-
played for about three seconds, then the previously dis-
played information reappears.
Interpreting Surround Channel Values
A: The number of front channels (3 means front left,
front right, and center).
B: The number of surround channels (2 means surround
left and surround right). If there’s surround back
channel information, this will be 3.
C: LFE channel for subwoofer (1 means yes).
Displaying Source Information
Press the [RECEIVER] button,
and then press the [DISPLAY]
button repeatedly to cycle
through the available informa-
tion.
RECEIVER
DISPLAY
RECEIVER
DISPLAY
Input source &
volume
Signal format*
or sampling
frequency
Input source &
listening mode
ABC
TX-NR702,602En.book Page 55 Tuesday, September 7, 2004 1:18 PM
To Next Page
Loading...
