EasyManua.ls Logo

Onkyo TX-SR602 - Page 40

Onkyo TX-SR602
96 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
40
First Time Setup—Continued
3
Press [ENTER].
The automatic speaker setup starts.
The test tone is output by each speaker
in turn, measured by the microphone,
and the speaker settings set accord-
ingly. The whole process takes about 90
seconds.
If any extraneous noise is picked up by
the microphone, the automatic setup
may not work correctly, so be careful.
4
When the Check Result menu
appears, press [ENTER].
The Setup Result menu appears.
5
Use the Up and Down [ ]/[ ]
buttons to select the item that
you want to check, and then
press [ENTER].
ENTER
Auto Speaker Setup
------------------------
Do not Unplug Setup Mic
Wait a moment, Please.
Auto Speaker Setup
------------------------
Do not Unplug Setup Mic
Left
Center
Right
Surr Right
SurrBack R
SurrBack L
Surr Left
Subwoofer
ENTER
Auto Speaker Setup
------------------------
Push Enter:Check Results
<:Retry >:Set
1Warning
2 Number of speakers and their sizes
3 Distance from each speaker to the
listening position
4 The optimum volume level for each
speaker
0.Auto Sp Setup Result
------------------------
1.Warning
2.Speaker Config
3.Distance
4.Level
ENTER
ENTER
Press the [RETURN] button to return to
the previous menu.
(Menus vary depending on country.)
*
1
When a speaker has a warning, its abbre-
viation (e.g., L, R, and so on) appears
instead of the “---” dashes.
If you want to adjust any of the settings
manually, see “Speaker Setup” on
page 46.
Note:
*
2
Please set any THX Certified speakers
manually to 80 Hz after Auto setup
operation (see page 46, 47).
6
When you’ve checked the set-
tings, press the [RETURN] button
to return to the previous menu.
7
When you’ve finished the auto-
matic setup, press the Right [ ]
button.
That completes the setup.
To run the automatic setup again,
press the Left [ ] button.
The automatic speaker setup starts
again.
8
Disconnect the speaker setup
microphone.
To cancel the automatic setup while it’s
in progress, disconnect the micro-
phone.
0-1.Warning
------------------------
-:-:-:--:--:--:--:--
Not Connect
Too Near/Far Speaker
-:-:-:--:--:--:--:--
0-2.Speaker Config
------------------------
Front :Large
Center :Small
Surround :Small
SurroundBack :Small
SurrBack ch :2ch
Crossover :100Hz
Subwoofer :Yes
0-3.Distance
------------------------
Left : 3.6m
Center : 3.6m
Right : 3.6m
Surr Right : 2.1m
Surr Back R : 2.1m
Surr Back L : 2.1m
Surr Left : 2.1m
Subwoofer : 3.6m
0-4.Level
------------------------
Left : 00dB
Center : 00dB
Right : 00dB
Surr Right : 00dB
Surr Back R : 00dB
Surr Back L : 00dB
Surr Left : 00dB
Subwoofer : 00dB
*
1
*
2
Auto Speaker Setup
------------------------
Push Enter:Check Results
<:Retry >:Set
ENTER
4SetupEn Page 40 Tuesday, September 7, 2004 3:32 PM

Table of Contents

Other manuals for Onkyo TX-SR602

Related product manuals