39
First Time Setup—Continued
2
Put the speaker setup micro-
phone at measurement point
1.
Notes:
• Make sure the microphone is hori-
zontal.
• If there’s an obstacle between the
microphone and any speaker, the
automatic setup will not work cor-
rectly. Set up the room as you would
when enjoying a DVD.
• Positioning the microphone close to
where your ears would normally be
will provide better results. You can
adjust the height of the microphone
by using a tripod or level table.
• It takes about 10 minutes to complete
the automatic speaker setup.
Connect the setup microphone
to the SETUP MIC jack.
Notes:
• If the AV receiver was previously
muted, it will be unmuted.
• Automatic speaker setup cannot be
performed while a pair of head-
phones is connected.
3
Press [ENTER].
The automatic speaker setup starts.
A test tone is output by each speaker in
turn, as the Audyssey2EQ function
determines which speakers are con-
nected. This takes a few minutes.
Note:
If any extraneous noise is picked up by
the microphone, the automatic setup
may not work correctly, so don’t make
any noise.
Auto Speaker Setup
========================
Please place microphone
at center of listening
area at ear height.
Push Enter:Next
Auto Speaker Setup
========================
Do not unplug Setup Mic.
Please, keep quiet.
Now measuring...
4
The speaker detect results
appear.
“Yes” means that the speaker was
detected. “No” means that no speaker
was detected.
If you agree with the results, use
the Up and Down [ ]/[ ] but-
tons to select Next, and then
press [ENTER].
The options are:
Next:
Proceed to the next step.
Retry:
Return to step 2 and try again.
Cancel:
Cancel the automatic speaker setup.
Auto Speaker Setup
========================
----SP Detect Result----
FL:Yes FR:Yes
SL:Yes SR:Yes
SBL:Yes SBR:Yes
C:No SW:Yes
------------------------
Next
Retry
Cancel
To Next Page
Loading...
