Onkyo TX-SR876 - Speaker Protect-2 (Current Detection)

TX-SR876/SA876
OPERATION CHECK-2
SPEAKER PROTECT-2 (CURRENT DETECTION)
1. Press and hold down
CD
button, then press
ON/STANDBY
button while the unit is powered on.
" Test - _ " is displayed only for 5 seconds.
2. Press GAME/TV button, while " Test - _ " is displayed.
The unit will be in the state of "
Test-4-00
".
3. Repeatedly press
TONE
+
button until
" Test-4-36 " is displayed.
4. Connect the dummy load of 3
ohms to the Front L ch speaker terminal.
At this time, confirm that the speaker relay is
not turned off.
5. Connect the dummy load of
1
ohm to the Front L ch speaker terminal.
Front R, Center, Surround L, Surround R, Surround Back L, Surroun R
At this time, confirm that the speaker relay is turned off and " Protect " is displayed.
Disconnect the dummy load immediately after checking the display of
" Protect ".
6. Check other channels according to the same procedure as 4 and 5.
[Procedure]
<Note>
No input.
Do not check two or more channels at the same time.
Do not connect a dummy load to speaker terminal longer than 2 seconds.
Test - _
Test - 4-00
[When]
1. Exchange the power transistors (Q6050 - 6056, Q6060 - 6066, Q6080 - 6086, Q6090 - 6096).
2. Exchange the amplifier PC board ass'y (NAAMP-9061, 9062, NACLA-9063 - 9069).
Test - 4-36
Clear
Turn off
7. Press
ON/STANDBY button.
Test - 4-36
Protect
Test - 4-36
Blinks