38
Basic Operations
Basic AV receiver Operation
1
Use the AV receiver’s input selector buttons to select an input
source.
To select an input source with the remote controller. Press the
[RECEIVER] button, and then press its INPUT SELECTOR buttons.
2
To turn the speakers on or off, use the AV receiver’s SPEAKERS
[A] and [B] buttons, or use the remote controller’s [SP A/B] button.
Pressing the remote controller’s [SP A/B] button cycles through the following
settings:
Speaker Set A→Speaker Set A&B→Speaker Set B→Off
Note that while speaker set B is on, speaker set A is reduced to 2.1-channel
playback.
See page 13 for more information about speaker sets A and B.
3
Start playback on the source component.
To watch a BD, DVD, or other video source, on your TV, select the video input
that’s connected to the AV receiver’s HDMI OUT, COMPONENT VIDEO
OUT, or MONITOR OUT.
On some DVD/BD players, you may need to change the digital or HDMI audio
output settings.
4
To adjust the volume, use the MASTER VOLUME control or the
remote controller’s VOL [q]/[w] button.
Since the AV receiver is designed for home theaters, it has a wide volume range
for precise adjustment. The volume can be set to Min, 1 through 79, or Max.
5
Select a listening mode and enjoy!
See “Using the Listening Modes” on page 49.
MASTER VOLUMESPEAKERS A/B
VOL
q, w
SP A/B
INPUT SELECTOR
RECEIVER
Input selector
Remote
controller
AV receiver
Remote
controller
AV receiver
↑
Remote
controller
AV receiver
To Next Page
Loading...
