Open Technologies S.r.l.
9. TRANSPORTATION – STORAGE
The buyer’s personnel can install the 3D scanner in the operating area after reading this manual.
As soon as the buyer receives the machine, he will have to check that the components have not suffered any
damages during transport, if any are noticed he will have to notify the carrier and the manufacturer immediately.
The scanner is protected by auto-shaping foam cushions and placed in a cardboard box.
When using the machine for the first time special attention must be paid to any-
thing that might seem to have an irregular operation and, if the case, contact Open
Technologies S.r.l. immediately, explaining the anomaly noticed. .
1.3. STORAGE CONDITIONS
If the 3D scanner is not installed inside the buyer’s premises but it is stored:
outdoors, suitable covers and precautions must be arranged to protect the components of the machine
from weather conditions (rain, snow, fog, humidity etc.).Check periodically for any damages that might
take place in the course of time;
indoors, no special precautions are required but just periodically check that the machine is stored cor-
rectly and the environmental conditions below are respected:
TEMPERATURE ( -20 ÷ +45 )°C
HUMIDITY ( 5 ÷ 85 )%
1.4. MOVING INSTRUCTIONS
Moving can be carried out with the help of trans pallet, trolleys or by hand seen the reduced weight and dimen-
sions.
1.4.1 Lifting
It is advised, for the operator to lift the machine holding it by its opposite sides.
The operator must pay attention when lowering the machine onto a surface to avoid
crushing of the upper limbs.
Edit N°: 00 - Rev. N°: 01 of 07/17/17 USE INSTRUCTIONS MANUAL
Nome file: NeWay User Manual 2017 rev01.odt Pag. 11 di 26
To Next Page
Loading...