Open Technologies NeWay - Instructions for Qualified Personnel

Open Technologies S.r.l.
Tabella 3 maintenance checks of the components
Tasks
Size and check
Materials used
d
2
w m
3
m
6
m
12
m
18
m
24
m
Clean the exterior of the 3D
scanner
Use a soft, dry cloth
1
Do not clean with in-
flammable substances
such as benzene, thin-
ners or wet cloths.
External connection cable
Check that the exter-
nal connection cable
is intact: no cracks or
cuts in the insulating
tape.
X
If there are cracks or
cuts replace the cable
immediately with a
new one or one made
by a qualified electri-
cian.
Test power switch Operating the switch
you check that there
is no power
1
Check external connectors
(USB, HDMI).
Make sure the con-
nectors are intact.
1
If the connectors are
damaged they must be
replaced immediately
with mew ones by a
qualified technician.
Overall inspection of the condi-
tions of the electrical system.
X
Refer to Open Tech-
nologies S.r.l. cus-
tomer service or to a
qualified technician.
1.27. INSTRUCTION RELATIVE TO THE INTERVENTIONS PERFORMED
EXCLUSIVELY BY QUALIFIED PEOPLE (MAINTENANCE PERSONNEL,
SPECIALISTS)
All electric interventions will have to be performed by a technician authorized by Open Technologies S.r.l.
1.27.1 Electric system
Check the switch is in working order, check for contact wear and tear and, if necessary, replace any. Periodi -
cally check that the voltage is correct, in order to avoid malfunctions or break downs.
1.27.2 Terminals
Just a periodical check to make sure the terminals are fastened properly, also, make sure the number on the
wire can be read and matches the terminal it is fixed to. Make sure the terminals are not damaged, if so, replace
it.
1.27.3 Electric Motor
Clean the electric motor by removing the dust on the frame, which could impair cooling, also make sure the
vents are not clogged.
Check, while the motor is running, the loudness and the presence of any slack in the supports.
Contact Open Technologies S.r.l. in case of any minimum slack and/or marked noise.
Check current absorption and voltage, matching them with those indicated on the tag.
2
d=days, w=weeks, m=months.
Edit N°: 00 - Rev. N°: 01 of 07/17/17 USE INSTRUCTIONS MANUAL
Nome file: NeWay User Manual 2017 rev01.odt Pag. 23 di 26