Open Technologies S.r.l.
13. MAINTENANCE
Any maintenance intervention performed on the 3D scanner can take place only after the ma-
chine has been unplugged, and a warning sign “WORK IN PROGRESS NO MANEUVERING”
should be affixed.
1.NATURE AND FREQUENCY OF INSPECTIONS
The 3D scanner routine maintenance should include an idling trial operation in order to identify abnormal noises
operation irregularities etc.,
It is necessary to keep a register (see Maintenance Register included at the end of this manual) to note down all
the maintenance operations and the relative comments.
The name of the service mane and the date the operation was carried out must also be clearly identifiable.
If some components need to be replaced, only original parts or parts approved by the manufacturer must be
used.
The use of non-original parts will not only void the guarantee, but can also compromise the correct operation of
the machine.
Maintenance interventions must be carried out by Open Technologies S.r.l. person-
nel or by authorized qualified technicians, under the manufacturer’s written autho-
rization, otherwise the warranty will decay immediately.
At delivery the Open Technologies S.r.l. qualified personnel or authorized resellers
will train the customer, this is all formalized with the signing of the training report.
Edit N°: 00 - Rev. N°: 01 of 07/17/17 USE INSTRUCTIONS MANUAL
Nome file: NeWay User Manual 2017 rev01.odt Pag. 22 di 26
To Next Page
Loading...