GSM/3G User Manual
11 | 82
Figure 1-7 Automatic Cluster
If you want to choose Manual Cluster, you should switch Detail on first.
There are 3 kinds of cluster mode: stand-alone, Master and Slave.
Stand-alone Mode: Run alone, total 4 ports.
Master Mode: Run as master with two different IP, controlling up to 10 slaves.
(The master can be accessed by the original IP. The target IP is used to
communicate with the slaves.)
Slave Mode: Run as slave with two different IP, controlled by the master. If the
original IP is forbidden, the slave can be accessed by the master with inward IP
only.
Notice: You can choose Remain Original IP address ON or OFF. If set it on, you can log
in your getaway with Original IP and Target IP.
To Next Page
Loading...
