Opex AS7200 - Page 66

66 Statistics
AS7200 User Manual - OPEX Corporation use only - not for distribution
- Time - set the start and end time for the report. In Figure 25, these
parameters were set to include the 3rd shift (12:00 AM-8:00 AM) and the
first shift (8:00 AM to 4:00 PM).
- Job/Operator Lists - select one of the radio buttons:
- C
URRENT JOBS/OPERATORS - To use the job names and operators currently
stored in the Controller’s memory (as shown in the Jobs and Operators
lists).
- R
EAD THRU PREVIOUS RUNS - To find runs deleted from the current list of
jobs and operators. For example, if a job file was deleted from the Job
Name frame, it is still stored in the stats file. You can access it by
selecting this radio button, then clicking the R
EFILL button.
4 In the Summary section, select one of the radio buttons:
- A
LL - to generate a statistics report for every job run that matches the
selected criteria
- J
OBS - to generate a statistics report sorted by job name(s)
- O
PERATORS - to generate a statistics report sorted by Operator name(s)
- Check the box to exclude jobs run by the OPEX Technician in your
report.
5 Click the Test M
ATCHING RUNS button to see how many jobs have been run
that match the criteria selected above. If N/A appears to the right of the
button, then there are no jobs to report that match the criteria listed.
- If a number appears after the M
ATCHING RUNS button, clicking OK will
generate a statistics report for the selected criteria.